Hi there, after all said and done ,I was informmed that the new main board i purchased for my printer Mutoh Rockhopper 1 has to be configured for paramiter settings, meaning the board came neaked. Does anyone know how to do the configuration ?
Sorry to bother you guys again on my Mutoh Rockhopper 1 printer. I discovered that each time I replaced the new mother board with the old damaged one , my printer completes initialization while the new one gives error 072 carriage imposition error. This my findings I reported to the mother board vendor and their reply was that the new board needs to be configured using a flash card and a parameter back-up card since the new board came to me naked . I have purchased the flash card and the parameter back-up card but I dont have a qualified tech. here in Nigeria , that means I have to do the configuration myself . Kindly assist me with stage by stage procedure for the installation and configuration of the new board so that I can resume printing .
Yeah , finally I got the maintenance manual and was able to use a flash card and a parameter back-up card to sort the printer's error 072 carriage imposition error out , I learn it was because the Motherboard came as a virgin and needed to be configured. But it only accepts media that is about 38" wide . If a media is wider than 38" inches it reports undefined media . what do I do to increase the media size to 62" ,the original size of the printer ?
